What the Combo Bezel Forming Block Does
The Pepetools Round & Oval Combo Bezel Forming Block is a hardened steel bench tool designed to help jewelers shape metal bezels around cabochons or faceted stones. With seven round holes and seven oval holes of matching diameters, it gives you a range of sizes for different stone dimensions.
Each hole is machined using EDM (electrical discharge machining) for a precise, consistent cavity. The block itself is surface ground on all sides to ensure a flat, smooth working surface. This matters when you need the bezel to sit perfectly level during forming.
Pepetools Combo Bezel Block at a Glance
- Round & Oval Combo Bezel Forming Block, 7 Round & 7 Oval Shapes: The block measures 80mm wide x 130mm long x 24mm thick. It includes 7 round holes (4, 5, 6, 7, 8, 9, 10mm diameter) and 7 oval holes of the same dimensions. These dimensions tell you the block fits on a standard bench without taking excessive space, and the hole sizes match common cabochon and stone dimensions.

Round & Oval Combo Bezel Forming Block, 7 Round & 7 Oval Shapes - Round & Oval Combo Bezel Forming Block, 7 Round & 7 Oval Shapes: The set includes a round bezel punch (124mm long, 16mm handle diameter) and an oval bezel punch (124mm long, 18mm handle diameter). Both have a 17-degree tapered cone that is 18mm in diameter and 26mm in length. The tapered cone centers the punch in the hole and applies even pressure around the bezel wall. The different handle diameters give you a tactile cue for which punch is in use.
How to Form a Bezel with the Combo Block
These steps assume you have a prepared bezel strip or pre-soldered bezel that fits the stone. The block forms the metal around the hole shape, not the stone itself.
The supplied information does not include specific operating instructions, so these steps are based on general bezel forming practice using this type of block.
- Choose the correct hole size: Select a round or oval hole that matches your stone's diameter or width. The hole should be slightly smaller than the stone so the bezel metal can be compressed around it.
- Position the bezel over the hole: Place the bezel (with the stone or a forming mandrel inside) over the chosen hole. The bezel should sit centered so the walls are supported evenly by the hole edge.
- Select the matching punch: Use the round punch for round holes and the oval punch for oval holes. The 17-degree tapered cone helps guide the punch into the bezel opening.
- Drive the punch with a hammer: Hold the punch vertically over the bezel and strike the handle end with a chasing hammer or mallet. The taper forces the bezel walls outward against the hole wall, forming the shape.
- Check and repeat if needed: Remove the punch and inspect the bezel. If the shape is not fully formed, reposition and strike again. The block's flat surface helps you see if the bezel sits evenly.
What the Supplied Information Does Not Cover
The product record confirms the block's dimensions, hole sizes, and punch specifications, but it does not include manufacturer instructions for operating speed, hammer weight, or specific stone-setting techniques. For those details, consult general jewelry fabrication references or your own bench experience.
The block is described as a professional-grade tool for accomplished bench jewelers. If you are new to bezel setting, you may want to practice on scrap metal first to learn how the taper and hole size interact with your hammering force.

