110mm 扁平超型軋機（含球墨鑄鐵框架）

I've been using this mill to roll copper down to .001" foil for etching, and the 4:1 gear ratio makes it easy to get consistent results without struggling. The flat rollers measure up exactly as specified, which is crucial for my jewelry work.

Finally got it dialed in for some thin stock work, and the flat area holding +/- 0.01mm across the full 110mm is no joke—my strips come out dead even edge to edge. The 4:1 reduction makes cranking through tougher metal feel smooth, not like I’m fighting the handle. Definitely the upgrade my bench ne

The 4:1 gear ratio makes a huge difference when I'm rolling metal—it's smooth and requires way less effort than my old mill. I was honestly surprised at how consistent the flat area is across the full 110mm width, holding tolerance within 0.01mm. It handles everything from thick sheet down to thin f