What This Graver Offers for Jewelry Engraving
The Round Graver (1.5") for LPFG is a pre-shaped, round graver made from hardened tool steel. It's designed to fit the Lion Punch Forge Adapter and any 1/8" shank quick-change (QC) system, making it a versatile tool for jewelry engraving and hand graver work. Its 1.5" overall length (38mm) and 1/8" (.125" or 3.1mm) shank size provide a compact, precise setup for detailed cutting.
Round Graver 1.5" for LPFG – Key Specifications
- Round Graver (1.5") for LPFG: 1.5" overall in length (38mm) The compact length offers excellent control for fine engraving work without excessive overhang.
Round Graver (1.5") for LPFG - Round Graver (1.5") for LPFG: 1/8" (.125" - 3.1mm) shank size This standard shank size fits most QC systems and the Lion Punch Forge Adapter, so you can swap gravers quickly.
- Round Graver (1.5") for LPFG: Round shaped graver (pre-shaped) made from hardened tool steel Pre-shaping saves initial grinding time, and hardened tool steel holds an edge well for consistent cuts.
How to Set Up the Round Graver for LPFG
Setting up this graver is straightforward because of its standard shank and pre-shaped tip. Follow these steps to get it ready for your engraving work.
- Check shank compatibility: Ensure your handpiece or QC system accepts a 1/8" shank. The graver works with any 1/8" shank QC system and the Lion Punch Forge Adapter.
- Insert the graver into the adapter or handpiece: Slide the shank fully into the collet or adapter. Tighten securely according to your tool's instructions. Do not overtighten.
- Verify graver orientation: Since the graver is round and pre-shaped, you can rotate it to find the cutting angle that suits your technique. Lock it in place once the desired orientation is set.
- Test the fit and movement: With the graver secured, run the handpiece at a low speed to check for wobble. If it runs true, you're ready to sharpen or begin engraving.
Sharpening the Round Graver – What You Need to Know
Sharpening a hardened tool steel graver requires a fine abrasive wheel or diamond lap. Because the graver is pre-shaped, you only need to refresh the cutting edge, not reshape it entirely. Use a light touch and maintain the original round profile to preserve the intended cutting geometry. The supplied evidence does not include specific sharpening angles or durations, so rely on your standard graver sharpening practices. Always wear eye protection and follow your sharpening tool's safety guidelines.
Maintenance Tips for Longevity
After each use, clean the graver with a soft cloth to remove metal debris. Store it in a dry place to prevent rust. Periodically inspect the tip for chips or dullness; a quick touch-up on a fine stone or diamond plate will extend its life. The graver is made in the USA from hardened tool steel, so it responds well to routine maintenance.
What the Evidence Doesn't Cover
The supplied information does not include specific sharpening angles, recommended speeds, or step-by-step sharpening instructions. It also does not mention any safety certifications or warranty details. For best results, follow your engraving tool manufacturer's guidelines for sharpening hardened tool steel gravers. The graver is sold individually or in packs of 5 or 10, so you can stock multiple tips for different projects.
