How to Use a Titanium Solder Pick for Jewelry Making

Quick answer

A titanium solder pick lets you place tiny solder balls exactly where you need them, using a pencil-like grip and a non-stick tip to avoid mess.

How to use a titanium solder pick: step by step

1. Hold the pick like a pencil: Grip the ErgoLast Titanium Solder Pick near the middle, just as you would a writing instrument. This gives you the most control for fine movements. Common mistake: holding too close to the tip reduces stability and can cause shaky solder placement.
2. Pick up a small solder ball: Touch the non-stick titanium tip to a small piece of solder. The solder will cling to the tip without sticking. You can also use the end twist to pick up solder from a flat surface. Checkpoint: if the solder doesn't lift, the tip may be too cold. Warm it slightly with your torch.
3. Position and drop the solder: Bring the pick to your joint or bezel and gently touch the solder to the heated area. The solder will flow off the tip cleanly. Use the paddle end to hold down a stubborn bezel while soldering. Common mistake: moving the pick away too quickly can drag the solder. Let it flow naturally before withdrawing.
4. Clean the tip after use: Wipe the tip with a damp cloth or use a brass brush to remove any flux residue. Titanium resists buildup, but regular cleaning keeps the non-stick surface effective. Checkpoint: never use abrasive tools on the tip—they can damage the non-stick coating.

Product facts

• ErgoLast Titanium Solder Pick: The ErgoLast Titanium Solder Pick is lightweight, sturdy, and has a unique slender design that allows you to hold it like a pencil. This design gives you precise control for dropping tiny solder balls directly to their destination, reducing cleanup and rework.